Using PeakCAN Plugin

The PeakCAN plugin encapsulates the low-level API to work with the PEAK-System CAN 适配器。

This plugin requires the PCAN device drivers and the PCAN-Basic library version 4.0.0 or higher. Supported platforms are Windows (pcanbasic.dll) and Linux (libpcanbasic.so).

创建 CAN 总线设备

At first it is necessary to check that QCanBus provides the desired plugin:

if (QCanBus::instance()->plugins().contains(QStringLiteral("peakcan"))) {
    // plugin available
}

Where peakcan 是插件名称。

Next, a connection to a specific interface can be established:

QString errorString;
QCanBusDevice *device = QCanBus::instance()->createDevice(
    QStringLiteral("peakcan"), QStringLiteral("usb0"), &errorString);
if (!device) {
    // Error handling goes here
    qDebug << errorString;
} else {
    device->connectDevice();
}

Where usb0 is the active CAN interface name. The PeakCAN plugin supports 16 USB interfaces from usb0 to usb15 and 16 PCI interfaces from pci0 to pci15 。 availableDevices() method returns a list of currently available devices.

注意： Only the USB and PCI adapters are currently supported by this plugin.

The device is now open for writing and reading CAN frames:

QCanBusFrame frame;
frame.setFrameId(8);
QByteArray payload("A36E");
frame.setPayload(payload);
device->writeFrame(frame);

The reading can be done using the readFrame() 方法。 framesReceived() signal is emitted when at least one new frame is available for reading:

QCanBusFrame frame = device->readFrame();

PeakCAN supports the following configurations that can be controlled through setConfigurationParameter() :

配置参数键	描述
QCanBusDevice::CanFdKey	This configuration option determines whether CAN FD frames may be sent or received. By default, this option is disabled. CAN FD compatible hardware is needed to enable this option.
QCanBusDevice::BitRateKey	Determines the bit rate of the CAN bus connection. The following bit rates are supported: 5000, 10000, 20000, 33000, 47000, 50000, 83000, 95000, 100000, 125000, 250000, 500000, 800000, 1000000. If the QCanBusDevice::CanFdKey option is enabled, the bit rates are limited to 125000, 250000, 500000, or 1000000. Note that this configuration parameter can only be adjusted while the QCanBusDevice is not connected.
QCanBusDevice::DataBitRateKey	Determines the data bit rate of the CAN FD bus connection. The QCanBusDevice::CanFdKey option must be enabled to allow setting this option. Possible data bitrates are 2000000, 4000000, 8000000, or 10000000. Note that this configuration parameter can only be adjusted while the QCanBusDevice is not connected.