Defines a cubic Bezier curve with two control points 更多...
| import 语句： | import QtQuick 2.7 |
The following QML produces the path shown below:
|
Path { startX: 20; startY: 0 PathCubic { x: 180; y: 0 control1X: -10; control1Y: 90 control2X: 210; control2Y: 90 } } |
另请参阅 路径 , PathQuad , PathLine , PathArc , PathCurve ，和 PathSvg .
Defines the position of the first control point.
Defines the position of the first control point.
Defines the position of the second control point.
Defines the position of the second control point.
Defines the positions of the control points relative to the curve's start.
If both a relative and absolute control position are specified for a control point's axis, the relative position will be used.
Relative and absolute positions can be mixed, for example it is valid to set a relative control1 x and an absolute control1 y.
另请参阅 control1X , control1Y , control2X ，和 control2Y .
Defines the positions of the control points relative to the curve's start.
If both a relative and absolute control position are specified for a control point's axis, the relative position will be used.
Relative and absolute positions can be mixed, for example it is valid to set a relative control1 x and an absolute control1 y.
另请参阅 control1X , control1Y , control2X ，和 control2Y .
Defines the positions of the control points relative to the curve's start.
If both a relative and absolute control position are specified for a control point's axis, the relative position will be used.
Relative and absolute positions can be mixed, for example it is valid to set a relative control1 x and an absolute control1 y.
另请参阅 control1X , control1Y , control2X ，和 control2Y .
Defines the positions of the control points relative to the curve's start.
If both a relative and absolute control position are specified for a control point's axis, the relative position will be used.
Relative and absolute positions can be mixed, for example it is valid to set a relative control1 x and an absolute control1 y.
另请参阅 control1X , control1Y , control2X ，和 control2Y .
Defines the end point of the curve relative to its start.
If both a relative and absolute end position are specified for a single axis, the relative position will be used.
Relative and absolute positions can be mixed, for example it is valid to set a relative x and an absolute y.
Defines the end point of the curve relative to its start.
If both a relative and absolute end position are specified for a single axis, the relative position will be used.
Relative and absolute positions can be mixed, for example it is valid to set a relative x and an absolute y.
Defines the end point of the curve.
另请参阅 relativeX and relativeY .
Defines the end point of the curve.
